Home > Products > Pressure sensor > Pressure transmitter >

CX-PT-3051 single flange pressure transmitter

The high-pressure constant flow pump has flow rate specifications of 10ml, 50 ml, 100 ml, 200 ml, 500 ml, 1000 ml and 3000 ml/min to meet the needs of analysis, semi-preparation and preparation.
INQUIRY

Brief Introduction

Widely used for measuring differential pressure (or pressure), level, density of liquid, gas or steam and convert the value of above into current signal output or digital protocol output.
The pressures are directly applied to the isolating diaphragm that provide isolation and resistance against process fluid corrosion.
Being microprocessor based, the electronic circuit is extremely versatile and accurate.
Combined with the sensor precision, it provides the high accuracy and range ability.
Transmitter performance is improved by continuous monitoring of the sensor temperature and corresponding corrections.
A local display permits easy reading and writing of data.

Dimension

Main Parameters

Medium	liquid, gas and steam
Measuring Range	0~0.1kPa to 0~40MPa
Output	4~20mA DC+HART protocol
Accuracy	±0.1%FS
Range and null point	Adjustable
Power Supply	12~45V DC, generally 24V DC
Protection	IP65
Storage Temperature	-40℃～+125℃
Overload Limit	150%-200% ofrated range
Load Resistance	≯750Ω(See below diagram 1 for load characteristic )
Relative Humidity	5~95%
Converter housing	Low copper cast aluminum alloy with Polyurethane paint
Fill Fluid	Silicon / Fluorine Oil
Process Connections	1/2NPT, 1/4NPT
Static pressure	4, 10, 25, 32Mpa
Mounting	Directly supported by piping or optionally with mounting bracket for 2" pipes or with direct or remote seals. 3-way valve
Maximum positive shift	500% of minimum adjusting span
maximum negative shift	600% of minimum adjusting span
Material	Flange/Adaptor	Stainless Steel 316/Monel/ Haste alloy/Carton Steel
	Drains/Vents	Stainless Steel 316/Monel / Haste alloy
	Diagrams	Stainless Steel 316/Monel /Haste alloy C/ Tantalum
	Wetted O-Ring	Viton/ Buna-N
	Seal O-Ring	Viton/ Buna-N
	Bolts & Nuts	Carton Steel/Stainless Steel316

Wiring Diagrams

Connect the bench equipment as shown in Figure, and turn on the HART-based communicator by pressing the ON/OFF key. The communicator will search for a HART-compatible device and will indicate when the connection is made. If the communicator fails to connect, it will indicate that no device was found.