How to set up the electromagnetic flowmeter

How to set the electromagnetic flowmeter, different media for accurate measurement of the electromagnetic flowmeter will have a deviation, the flowmeter in the factory before each have to do the real flow calibration, but for different conditions on the site, or the measurement of different media, the application of the electromagnetic flowmeter is also a little deviation.So how do we set it up correctly when we apply the new electromagnetic flowmeter?

Before setting the parameters of the instrument, check the correct connection method (including the power line) of the instrument on the pipeline and the fastness of installation.Then, the sensor part should be well grounded, and the fluid in the pipeline should be static when debugging the zero point of the instrument.

When the instrument is switched on, that is, when the instrument is powered on, the instrument will automatically enter the measurement state. In the measurement state, press "compound key + confirm key" to appear the interface of converter function selection, that is, the interface of parameter setting.

Specific setting parameters, according to the situation of the measured liquid to choose the setting parameters, the specific operation is more cumbersome, here is not a description, the specific setting operation to look at the description is a book, each type of intelligent electromagnetic flowmeter specifications have detailed operation instructions.

When the panel is set, there will be a function conversion interface, that is, "compound key + confirm key", and then press "up key" or "down key" to change the screen interface operation by "parameter setting, total reset, coefficient change".

In addition, intelligent electromagnetic flowmeter is generally equipped with a remote control, which is the same as the operation of the instrument screen. When operating the transmitter of the remote control, it should be aligned with the receiver of the instrument, that is, the two are flush and the operating distance is less than 1 meter.

Matters needing attention

Because the parameter setting of intelligent electromagnetic flowmeter is more, so here is only a simple explanation of the setting method, only for reference.

The password set in the parameters of each meter is classified, which is set according to the specific situation.

The flow meter can meet the needs of most markets, including water, oil, food, lubricating oil, chemistry, cosmetics, ink, pharmaceutical, coating, petroleum, automobile, glue, polyurethane, electrolyte and additives.