Domestic flowmeter manufacturer chooses which good

Domestic flowmeter which good, micro flowmeter is used for precise continuous or discontinuous measurement of the total flow of liquid flow through the pipeline volumetric flowmeter, micro flowmeter is equipped with a pair of elliptical gear rotor measuring chamber, sealed coupling and counting mechanism.Micro-flowmeter is a field accumulative instrument, with the advantages of simple structure, reliable use, high precision, small pressure loss, less affected by the change of liquid viscosity, wide range of measurement, easy installation and so on.The series of flowmeters are mainly used in petroleum, chemical, grease products and other industries.

The micro flowmeter has high measurement accuracy and is applicable to the measurement of flow rate of medium with high viscosity, but it is not applicable to the fluid containing solid particles. If the measured liquid medium contains gas, measurement error will be caused.Usually small flow meter accuracy can reach 0.2, is a kind of more accurate flow measurement instrument, however, if the use of the measured medium flow rate is too small, an ordinary small flow meter instrument will highlight the influence of the leakage error, but our flow meter can measure high viscosity of the liquid could measure low viscosity liquid, can guarantee enough accuracy of measurement.

Can measure a variety of media, including low and medium viscosity of a variety of clean liquids.Its range ratio up to 40:1, can meet the flow span is larger occasion.Easy installation, aluminum and stainless steel and other materials available.Using the latest technology and materials.Accurate and reliable measurement.

What are the precautions for micro flowmeter?

1) during on-site installation, it should be noted that the arrow direction on the flowmeter shell is consistent with the flow direction of the fluid;

2) the flowmeter shall be installed on a pipe with the same nominal inner diameter as the inlet and outlet joint. When the pipe is connected with the flowmeter, the sealing part shall not be injects into the fluid;

3) the measured flow body should be filled with the measuring chamber of the flowmeter and its front and rear connecting pipes. If the measured flow body contains gas, a gas separator should be installed before the flowmeter and filter;

4) for the pipeline in continuous operation, when the flowmeter is installed in the horizontal pipeline, the bypass pipeline should be installed to facilitate cleaning and maintenance;When the flowmeter is installed on the vertical pipe, it should be installed in the bypass pipe to prevent debris from falling into the meter.The vertical pipe above the flowmeter should be as short as possible to reduce the precipitation of impurities in the upper piping when the flow direction of the fluid is from the bottom up